Hot Water & Central Heating


Hot Water & Central Heating

[/vc_column_text][vc_separator][/vc_column][/vc_row][vc_row][vc_column][vc_column_text]The controls for the hot water supply is situated behind the living room door.

In the event that there is no hot water supply or if it has been exhausted, please refer to the instructions below.


Usually for showers there should be enough hot water to go round in the mornings or evenings. However if you wish to run TWO or more warm/hot baths in succession during these times then the hot water supply would need to be “Boosted” or when baths are run during off peak times such as mid mornings or mid afternoons, then it would also need to be “Boosted” to ensure that there is enough to go round.

To “Boost” and ensure that there is enough hot water to fill your baths, press the button once (stays boosted for 1 Hr), twice (stays boosted for 2 Hrs) or three times (stays boosted for 3 Hrs). Note that you would only have to do this once before you run your bath. The system will automatically “recharge” the hot water supply overnight.


Central Heating

[/vc_column_text][vc_separator][vc_column_text]The Climate Control for each room can be adjusted via the control panel in the master bedroom.

Select the room to be adjusted and use the Up or Down arrow keys to set the desired temperature. Once it is set, the system will automatically bring the temperature of each room independently up or down to the required setting.[/vc_column_text][/vc_column][/vc_row]